OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
24
Fig. 29
Fig. 30
Fig. 31
2.11.1
IMPROPER USE DURING MAINTENANCE
•
Do not use open fire in the vicinity of hoses under high
pressure. Damage to any hose under high pressure may
cause the leakage of flammable liquid (fuel, oil) and
result in severe burns.
•
Never attempt to remove hydraulic hoses or other
devices (air conditioner) under high pressure.
•
Do not perform an inspection of the tractor if safety
devices are not “activated”.
•
Do not lubricate, repair or adjust the tractor when the
tractor is moving.
•
Do not touch any moving parts! Turn off the drive and make sure that the hydraulic
circuit is not under operating pressure.
•
Do not perform any maintenance work during operation of the
tractor. Stop the tractor when the conditions are safe.
•
Tyres should only be replaced by a qualified person, who has
access to suitable equipment, is certified and able to provide
professional installation.
•
Never install or remove a tyre from the rim if you are not
qualified to do so and do not perform this operation without
using suitable tools or machines.
•
Always remove the tyre before repairing a damaged rim. If you
are not suitably equipped to perform this operation, leave it to a
qualified person.
•
Never install damaged rims or tyres on the tractor.
•
Never exceed the maximum tyre pressure, otherwise the
tyre could explode.
•
Do not add the coolant when the engine is hot.
•
Never connect the battery terminals together. This may
cause an explosion.
•
Do not smoke or have open flames (welding) near the area
where the battery is being charged.
•
To clean the electric components, do not direct a water jet
directly on electric components.
2.12
SAFETY INSTRUCTIONS FOR OPERATING THE TRACTOR WITH
WEIGHTS INSTALLED
When operating the tractor with weights installed, as required by the specific situation, certain
precautions must be taken, in particular those regarding safety.
•
Unevenly installed weights significantly affect tractor balance, therefore, always install
weights in symmetry, according to the type of implement attached and the type of surface
where the work is carried out.
•
If you ballast the tractor by putting water in tyres, only perform this operation if you are
suitably qualified, otherwise let a qualified person to do this.
•
When water ballasting the tyres during winter, add antifreeze to the water.
•
When driving with heavy or long implements, always put weights to the front of the
tractor.
•
When detaching an implement from the tractor, you must always remove the weights to
avoid tractor instability, reduce the wear of vital components and increase functionality.
Summary of Contents for AGT 106
