OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
211
Malfunction
Cause
Solution
The engine operating
temperature is low.
Thermostat malfunction, the
thermostat is damaged.
Replace the thermostat. This operation can
only be performed by an authorized
service centre. (*)
The
indicator
on
the
dashboard is damaged.
Consult an authorized service technician.
(*)
Excessive engine oil
consumption.
The
oil
viscosity
is
unsuitable.
Replace the oil with the prescribed type.
Refer to the chapter “Maintenance”.
External oil leakage.
Fix (tighten) the joints and leaking
surfaces. Consult an authorized service
technician. (*)
The engine oil level is too
high.
Lower the engine oil level. Refer to the
chapter “Maintenance”.
The valve guides, seals or
piston rings are worn.
A major service on the engine is required,
contact an authorized service technician.
Fuel consumption is
too high.
The air filter is blocked.
Clean or replace the filter. Refer to the
chapter “Maintenance”.
The engine is overloaded.
Shift into a lower gear, reduce the towing
load.
The injection nozzles are
dirty or damaged.
Clean or replace the injection nozzles.
This operation can only be performed by
an authorized service centre. (*)
The engine ignition is not
adjusted properly.
Adjust the ignition. This operation can
only be performed by an authorized
service centre. (*)
Black smoke coming
from the exhaust
system.
The injection nozzles are
damaged or blocked.
Clean or replace the nozzles. This
operation can only be performed by an
authorized service centre. (*)
The air filter is dirty.
Clean or replace the filter. Refer to the
chapter “Maintenance”.
The DPF filter is damaged.
Consult an authorized service technician.
(*)
8.12.3
TRANSMISSION MALFUNCTIONS
Malfunction
Cause
Solution
Gear shifting
is difficult.
The
clutch
does
not
disengage fully.
The clutch disks are worn. This operation can only
be performed by an authorized service centre. (*)
Presence of air in the hydraulic system, bleed the
system. Consult an authorized service technician. (*)
Check the brake fluid level and add if necessary.
The gearbox shift fork or
synchronizers are worn.
The gearbox must be repaired. This operation can
only be performed by an authorized service centre.
(*)
The operation
is too noisy.
The oil level is too low.
Check the hydraulic oil level and add if necessary.
Refer to the chapter “Maintenance”.
The
oil
viscosity
is
unsuitable.
Replace the oil with the prescribed type. Refer to the
chapter “Maintenance”.
The bearings are worn or the
components are broken.
This operation can only be performed by an
authorized service centre. (*)
(*) - These operations should only be performed by an authorized service technician!
Summary of Contents for AGT 106
