OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
68
Fig. 64
Fig. 65
To disconnect the brake pedals, follow the procedure shown in the figure Fig. 64. Pull the safety
latch upwards (figure 1), then move it to the left (figure 2) and insert it back into the groove
(figure 3). The pedals are now disconnected; to connect the pedals, repeat the procedure in
reverse order.
When the seat is turned, the brake pedals are pushed upwards and must be connected during this
procedure!
4.8.3.2
PARKING BRAKE
The parking brake is activated with a lever and it is completely independent of the working
brakes. It is designed to block the wheels when the tractor is not moving, when operating in idle
or when the tractor is completely stopped.
For safety reasons, when the tractor is
stopped and the user leaves the driver’s
seat without activating the parking brake,
a beeper sounds after 2 seconds and the
parking brake lamp on the dashboard
starts to flash (see 65). Activate the
parking brake.
WARNING:
The pedals can only be disconnected when working with the tractor.
When driving on public roads, always make sure that the brake pedals are
connected!
WARNING:
When driving the tractor uphill, the brake pedals must always be
connected! The pedals must also be connected if the seat is reversed.
WARNING:
Never leave the driver's seat when driving the tractor!
Summary of Contents for AGT 106
