OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
115
Fig. 131
6.3
ADJUSTING THE REAR HYDRAULIC LIFT MECHANISM
With suitable adjustments, this tractor model allows for the connection of category I implements.
Before connecting an implement for the first time, it is important to check that the weight does
not exceed the maximum permissible axle load on the tractor.
If you believe that the tractor would be too unstable with the implement connected, install
appropriate weights to increase stability.
The rear hydraulic lift mechanism must be adjusted whenever you change the implement and the
attachment points are arranged differently than on the previous implement.
According to requirements, the rear hydraulic lift mechanism can be adjusted in several different
ways, as described below.
1.
Adjusting the lower link arms
2.
Adjusting the vertical tensioners
3.
Adjusting the top link
4.
Adjusting the lateral tensioners
Before adjusting the rear hydraulic lift mechanism
•
Drive the tractor to the implement to be installed.
•
Lower the lower link arms to the height of connection points on the implement.
•
Stop the tractor when the conditions are safe, if necessary, secure it with safety wedges.
Summary of Contents for AGT 106
