OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
209
Malfunction
Cause
Solution
The engine does not
start.
Incorrect fuel type.
Completely drain and clean the tank and
fuel lines. Add the correct fuel type. Refer
to the chapter “Tank filling”.
The fuel pump is not
working properly.
Replace the fuel pump. This operation can
only be performed by an authorized
service centre. (*)
Check the electrical system on the pump.
If the malfunction persists, consult an
authorized service technician. (*)
The glow plug fuse in the
control device is damaged.
Replace the fuse. Refer to the chapter
“Fuses”.
Engine
control
unit
malfunction.
Check the fuses and relays. Refer to the
chapter “Fuses”.
Consult an authorized service technician.
(*)
Engine control unit failure.
Consult an authorized service technician.
(*)
Sensors on safety devices are
damaged.
Consult an authorized service technician.
(*)
High-pressure
pump
malfunction.
Check if the pump functions properly;
replace if defective. This operation can
only be performed by an authorized
service centre. (*)
Check the electrical current on the pump.
If there is no current, check the control
device fuse. This operation can only be
performed by an authorized service centre.
(*)
EGR valve malfunction.
Replace the EGR valve. This operation
can only be performed by an authorized
service centre. (*)
The EGR valve must be cleaned. This
operation can only be performed by an
authorized service centre. (*)
The ignition switch is
damaged.
Replace the switch. Consult an authorized
service technician. (*)
The PTO drive shaft switch
is activated.
Disengage the PTO drive shaft. Refer to
the chapter “Tractor console”.
The lever for changing the
driving direction (inverter) is
not in neutral position.
Move the lever in neutral position. Refer
to the chapter “Starting the tractor”.
The clutch pedal has not
been activated.
Depress the clutch pedal. Refer to the
chapter “Starting the tractor”.
The driver is not in the
driver's seat.
Sit on the driver's seat. Refer to the
chapter “Starting the tractor”.
The starter is not
working.
The main fuses are damaged. Replace the fuses. Refer to the chapter
“Fuses”.
Main
battery
switch
malfunction.
Check the cable connections.
Replace the switch. Consult an authorized
service technician. (*)
(*) - These operations should only be performed by an authorized service technician!
Summary of Contents for AGT 106
