OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
177
Fig. 208
8.4
CLEANING THE TRACTOR
Clean the tractor with a water jet, taking care not to point it towards electrical parts, particularly
the engine assembly, where the air filter, alternator and starter are installed. If you decide to
clean the engine, protect these parts with suitable covers.
To clean the tractor, only use biodegradable cleaning products, which can be mixed with water.
You can use compressed air to dry the tractor, which is also appropriate for cleaning or blowing
dusty parts. After cleaning, always apply grease to all grease nipples to ensure that the sliding
surfaces are protected against corrosion.
8.5
ENGINE MAINTENANCE
Before performing any maintenance work on the engine, comply with the instructions described
below.
•
Stop the tractor in safe conditions and in a suitable area.
•
If the tractor was operating, wait until the engine cools down enough.
•
Remove the key from the ignition lock.
8.5.1
CHECKING THE ENGINE OIL LEVEL
To check the level, follow the procedure described below.
•
Park the tractor on a horizontal surface.
•
Pull out the oil level dipstick from the engine compartment. The dipstick is located on the
left side of the engine under the starter.
•
Check the oil level (minimum and maximum), add more oil if necessary but do not fill
beyond the maximum mark.
•
After you finish this task, insert the oil level dipstick back in its place.
WARNING:
Do not use aggressive chemicals or hydrocarbon solvents,
particularly when cleaning plastic components and painted surfaces!
Summary of Contents for AGT 106
