Agromehanika AGT 106, Operating Instructions Manual

Page: 139 / 245

OPERATING INSTRUCTIONS AGT 1060 Rev.09/2020
138
Fig. 160
Conditions for engaging the PTO drive shaft, driver in the seat (short description)
Condition
no. Action
1 Driver's seat activated
2 All PTO control levers activated
3 The switch on the console is activated
7.6.1.2 PTO DRIVE SHAFT ENGAGEMENT THROUGH THE SWITCH ON THE FENDER
The PTO drive shaft can be engaged with the external switch when the operator works outside of
the driver’s area or when not seated in the driver's seat.
It can only be engaged if the PTO engagement switch on the console is activated!
•
The tractor's engine is running, all conditions for engaging the PTO drive shaft have been
fulfilled; refer to the chapter “PTO drive shaft engagement through the switch on the
console”.
•
Activate the parking brake.
•
Press the switch on the fender and release it (1 second).
•
Press the switch again and hold it for 5 seconds.
•
The PTO drive shaft is engaged.
The external switch for engaging the rear PTO drive shaft is located on the rear left fender and
the switch for engaging the front PTO drive shaft (if installed as an option) on the front left
fender.
IMPORTANT: For safety reasons, the PTO drive shaft will disengage after 7
seconds when the driver leaves the seat! It can only be engaged again when the
operator sits back on the seat or engages the shaft through the external switch on
the fender.
WARNING: If an implement is installed on the tractor, always make sure that the
safety pins on the universal joint are properly locked before engaging the PTO
drive shaft.