OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
181
Fig. 215
8.5.5
CLEANING THE AIR FILTER
As a precaution, if the tractor is used in a dusty environment, it is recommended to check the
filter for blockage sooner and clean it if necessary.
Cleaning the filter insert with compressed
air
•
To disassemble the air filter, refer to
the chapter “Changing the air filter”.
•
Point the compressed air jet directly
towards the inside of the filter insert.
The air pressure must not exceed 3
bar.
•
Move the air jet nozzle across the
entire surface, along the paper folds,
until all the dust is removed. Take
care not to damage the filter during
this operation.
•
After cleaning, the filter must be
checked for damages (holes, cracks).
In this case, replace it with a new one.
IMPORTANT:
The external filter insert must be replaced after 6 cleaning
operations, while the internal filter insert is not cleaned and must be replaced with
every second replacement of the external filter insert.
WARNING:
Always use safety glasses and safety mask when cleaning dust and
other particles from the filter to prevent contact with eyes and respiratory system!
Summary of Contents for AGT 106
