![Agromehanika AGT 106 Operating Instructions Manual Download Page 189](http://html1.mh-extra.com/html/agromehanika/agt-106/agt-106_operating-instructions-manual_2870068189.webp)
OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
188
Fig. 223
8.7
TRANSMISSION MAINTENANCE
Before performing any maintenance work on the transmission assembly, comply with the
instructions described below.
•
Stop the tractor in safe conditions, on a horizontal surface, lower the hydraulic lift
mechanisms (front and rear) and lower the rest of the equipment, powered by the gearbox
oil.
•
If the tractor was operating, wait until the engine cools down enough.
•
Remove the key from the ignition lock.
8.7.1
CHECKING THE GEARBOX OIL LEVEL
Before checking the gearbox oil level, the tractor must always be parked with the engine turned
off to allow the parts to cool down. Check the oil level on the indicator at the rear of the tractor,
next to the PTO drive shaft. If you see oil inside the indicator, there is enough oil. If the indicator
is empty, you must add more oil, refer to “Changing the gearbox oil”.
8.7.2
CHANGING THE GEARBOX OIL
To change the gearbox oil, follow the procedure described below.
•
Safely park the tractor on a horizontal surface.
•
Move all control devices to neutral position.
•
Place a suitable collection container for used oil under the drain plug on the bottom of the
gearbox.
•
Loosen the drain screw (A) and wait until the old oil is drained into the container.
•
Re-tighten the screw on the gearbox.
•
If necessary, you must also replace the oil filter for the hydraulic system, refer to
“Changing the hydraulic oil filter”.
•
Loosen the filler screw (B).
•
Add the prescribed type of oil with a suitable viscosity that meets the requirements, refer
to the chapter “Technical data of the tractor - oil”.
•
Add oil until you can see it in the indicator, refer to the chapter “Checking the gearbox oil
level”.
•
Re-tighten the screw (B).
Summary of Contents for AGT 106
