OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
179
Fig. 211
Fig. 212
8.5.3
CHANGING THE OIL FILTER
To change the oil filter, follow the procedure described below.
•
Drain the engine oil, refer to “Changing the engine oil”.
•
Using a suitable tool (1), unscrew the plastic housing (2) of the oil filter and remove it.
The housing has a special structure where a socket wrench can be inserted.
•
Remove the old oil filter (3) and replace it
with a new original filter.
•
Replace all seals on the plastic housing and
lubricate them with oil.
•
Install the housing back in its place and
securely tighten it by hand; you can also use a
tool in the end.
•
Clean any oil residues from the engine
surfaces.
WARNING:
Used engine oil must not be disposed of in the environment. In
accordance with applicable regulations, it must be collected in suitable collection
containers.
WARNING:
Do not use excessive force when tightening the plastic housing with
a tool, otherwise it may crack. Use appropriate tightening torques.
Summary of Contents for AGT 106
