OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
199
8.10
GREASING POINTS ON THE TRACTOR
To ensure proper operation, regularly grease the parts with grease fittings according to the
prescribed intervals. The following page contains some advice which must be followed.
•
Every 50 hours of operation, all moving parts must be properly greased.
•
If the tractor is cleaned with a high-pressure washer, greasing is recommended after each
cleaning.
•
Stop applying grease when it comes out of the moving section. On places where these are
not visible, stop applying sooner.
The moving parts on the transmission and hydraulic lift mechanisms are equipped with grease
fitting types specified in the table.
Grease fitting type
Standard
Description
Illustration
Type A
DIN 71412
Straight grease
fitting
Type B
DIN 71412
45° angle grease
fitting
Type C
DIN 71412
90° angle grease
fitting
WARNING:
Before greasing, the carefully clean the grease fittings and the
greasing pump to prevent the grease from being mixed with dirt!
Summary of Contents for AGT 106
