OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
162
Fig. 185
Fig. 186
8.2
WHEELS
Comply with the following instructions before changing the wheels.
•
Park the tractor on a solid and level surface, activate the parking brake and immobilise
the tractor by placing safety wedges under the wheels.
•
Remove the key from the ignition lock to prevent accidental starting.
8.2.1
REMOVING AND INSTALLING WHEELS
For lifting the tractor, use a stable hoist with a sufficient load carrying capacity and install it on
the recommended lifting points, refer to the chapter “Tractor lifting points”.
•
Before removing the wheel, lift
the tractor and support it with
an appropriate support stand
(1).
•
Wait until the wheel is lifted
from the ground, then unscrew
all the nuts (2) and remove the
wheel (3).
•
When re-installing the wheel,
use appropriate tightening
torques.
•
After the work is finished, lift
the tractor, remove the
support stand and lower the
tractor to the ground.
•
Check that the wheel nuts and
screws on the rims are
properly tightened.
WARNING:
When removing the wheel, make sure that the tractor securely rests
on its support and there are no people inside the danger area when changing the
wheel.
WARNING:
Do not start the tractor until the wheel changing procedure is
completely finished!
Summary of Contents for AGT 106
