Agromehanika AGT 106, Operating Instructions Manual

Page: 131 / 245

OPERATING INSTRUCTIONS AGT 1060 Rev.09/2020
130
Fig. 150
If the engine does not start
•
Before attempting to restart the engine, wait at least one minute to allow the starter to
cool down.
•
Before making another attempt to start the engine, first turn the key to position 0 and
repeat the procedure described above.
7.3.2 SHUTTING OFF THE ENGINE
If the tractor was exposed to an extended period of operating under load and the engine is very
hot, always leave it running in idle for at least a few minutes before you shut it off.
To shut off the engine, follow the instructions below, see Fig. 149
•
Release the accelerator pedal; refer to the chapter “Driving controls”.
•
Depress the clutch pedal (C) and the foot brake pedal (H) to stop the tractor.
•
If engaged, disengage the PTO drive shaft (F and E).
•
If used, move the accelerator lever (G) to the minimum position.
•
Move the lever for changing the driving direction (D) to neutral position.
•
Pull the parking brake (I).
•
Shut off the engine by turning the key (B) to position 0 on the main switch.
•
Remove the key and close the lock with the guard.
WARNING: DO NOT accelerate to full speed when the engine is cold,
particularly if the tractor is equipped with a turbo charger. Leave the engine
running for at least a few minutes to ensure that the oil is heated slowly and the
engine parts are properly lubricated!
WARNING: Do not try to perform several starting attempts one after the other to
avoid damaging the starter. If this cannot be avoided, wait at least 15 to 20
seconds before making another attempt. A maximum of four attempts are allowed.
WARNING: Stop the tractor when the conditions are safe and make sure that it
cannot be started by another person. The tractor must not be parked in areas where
it could represent an obstacle or any risk for other people.