Agromehanika AGT 106, Operating Instructions Manual

Page: 211 / 245

OPERATING INSTRUCTIONS AGT 1060 Rev.09/2020
210
Malfunction Cause Solution
The starter is not
working. The starter is damaged. Replace the starter. Consult an authorized
service technician. (*)
Discharged battery. Charge or replace the battery. Refer to the
chapter “Changing the battery”.
The battery terminals are
oxidised,
there is no
electrical contact.
Clean and grease the surfaces of both
terminals. Refer to the chapter “Changing
the battery”.
The engine is
knocking. Low engine oil level.
Shut off the tractor’s engine
immediately! Check the engine oil level
and add if necessary. Refer to the chapter
“Maintenance”.
If the malfunction persists, consult an
authorized service technician. (*)
Low fuel pressure in the
supply. The filters are blocked, replace the fuel
filters. If the malfunction persists, consult
an authorized service technician. (*)
Fuel pump malfunction.
Engine performance is
reduced. The engine is overloaded. Shift into a lower gear and reduce the
towing load.
The air filter is blocked. Clean or replace the filter. Refer to the
chapter “Maintenance”.
The DPF filter is blocked,
the engine is running in
forced mode. Perform a forced filter regeneration.
If this solution does not resolve the
problem, contact an authorized service
centre as soon as possible to avoid serious
damage to the engine of the tractor! (*)
The fuel filter is blocked. Replace the main and the auxiliary fuel
filter.
Fuel pump malfunction. It may be blocked. Clean and bleed the
pump, replace if necessary. This operation
can only be performed by an authorized
service centre. (*)
The intake or the exhaust
system is damaged. Consult an authorized service technician.
(*)
The engine is
overheating, a warning
lamp illuminates on the
dashboard
during
operation.
The coolant level in the
system is too low. Check the cooling system for potential
leaks, add coolant to the proper level.
Refer to the chapter “Maintenance”.
The radiator is dirty or
blocked (radiator fins). Clean the radiator fins. Refer to the
chapter “Maintenance”.
Engine thermostat
malfunction.
Replace the thermostat. Consult an
authorized service technician. (*)
Temperature indicator
malfunction.
Replace the thermal switch. Consult an
authorized service technician. (*)
The belt is faulty. Check the belt tension, if the belt is worn
out, replace it. Refer to the chapter
“Maintenance”.
(*) - These operations should only be performed by an authorized service technician!