OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
17
Fig. 20
2.6
SAFETY INSTRUCTIONS AFTER OPERATING THE TRACTOR
Before exiting the tractor or leaving the tractor unsupervised, take the following safety
precautions.
Observe the concept “Tractor stopped under safe conditions with the engine running”:
•
Stop the tractor.
•
Activate the parking brake.
•
Move all controls to neutral position.
•
Always lower the three-point linkage.
•
Always lower any tractor mounted equipment to the ground.
•
Disengage the PTO drive shaft when not in use.
•
Before exiting, make sure there are no persons nearby.
•
Move all hydraulic system controls to neutral position if they are
not used.
•
Climb from the tractor and put wedges under the wheels if necessary.
Observe the concept “Tractor stopped under safe conditions with the engine stopped”:
•
Stop the tractor.
•
Move all controls to neutral position.
•
Activate the parking brake.
•
Always lower the three-point linkage.
•
Always lower any tractor mounted equipment to the ground.
•
Make sure the PTO drive shaft is disengaged.
•
Move all hydraulic system controls to neutral position.
•
Stop the tractor's engine, shift into the first gear to increase safety and remove the key.
•
Climb from the tractor and put wedges under the wheels if necessary.
Observe the concept “Tractor stopped under safe conditions with a trailer without brakes
or with an overrun brake attached”:
•
Stop the tractor on a level surface.
•
Repeat the procedure described above: “Tractor stopped under safe conditions with the
engine stopped”.
•
Activate parking brake on the trailer (if equipped, see the trailer's operating instructions).
After you finish using the tractor or before parking the tractor for an extended period of time,
perform the general safety-related measures.
•
Park the tractor on a level and solid ground, in a covered area or an area where the tractor
can be covered without potential risks or obstacles.
•
Stop the tractor when conditions are safe, as described above, and prevent other persons
from accessing the controls in the driver's area; lock the door if the tractor is equipped
with a cab.
•
Disconnect the negative (-) terminal from the battery. When preparing for winter storage,
remove the battery from the tractor and store it at an appropriate room temperature to
prevent electrolyte freezing.
•
If installed, lower the tractor mounted implement to the ground.
2.6.1
IMPROPER USE OF THE TRACTOR
•
Do not park the tractor in confined spaces, otherwise the vicinity of a hot engine may
cause a fire or damage to other property.
•
Do not leave the driver’s area before ensuring that the safety precaution of stopping the
tractor was correctly performed.
Summary of Contents for AGT 106
