OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
183
Fig. 196
8.5.6.1
CHANGING THE AUXILIARY FUEL FILTER
The auxiliary filter is installed under the cover of the tank. It is designed to prevent larger
particles from entering the fuel circuit. If you see there are many particles present through the
transparent housing, replace the filter.
To change the auxiliary filter, follow the procedure described below.
•
Unscrew the fuel filler cap at the top of the tank (A).
•
Unscrew the screws on the cover of the tank (B) and remove the cover.
•
Unscrew the clamps (1 and 2) on the fuel filter (C).
•
Remove both hoses from the filter and block them with a plug to avoid fuel spillage.
•
Remove the screw (3), remove the old fuel filter and replace it with a new original filter.
•
Tighten the screw (3) and fasten the filter in its place.
•
Install both hoses back onto the filter and make sure to install them in correct order (inlet
– outlet) and tighten the clamps.
IMPORTANT:
DO NOT clean the auxiliary fuel filter.
WARNING:
Do not use excessive force when tightening the clamps on the
auxiliary filter to avoid damaging the filter.
Summary of Contents for AGT 106
