OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
164
Fig. 189
8.2.2.1
TYRE PRESSURE CHECK
Check the tyre pressure with the tractor weights and implements removed and by following the
procedure described below.
•
Stop the tractor on a level and solid surface.
•
Shut off the tractor's engine (ignition key in position 0).
•
Visually check the tyres for potential wear.
•
Check the tyre pressure.
Tyre pressure for operating the tractor on soft surfaces, e.g. soil
•
A Correct tyre pressure
for the work to be carried out; it provides a good grip, the soil
correctly enters the tyre tread when driving, the tyre tread remains clean.
•
B The tyre pressure is too low
for the work to be carried out, giving poor results
because the grip on the ground is poor, the soil does not enter the tyre tread correctly
when driving, the tyre surface can be damaged, particularly when pulling heavy loads.
•
C The tyre pressure is too high
for the work to be carries out, giving poor results
because the grip on the ground is poor; such aggressive tyre tread may damage the
ground significantly and there is a high risk of damaging the tyre in case of impact.
Tyre pressure for operating the tractor on hard surfaces, e.g. road
•
D Correct tyre pressure
for the work to be carried out, enabling the optimum
preservation of the base layer and reducing the wear of the tyre tread.
•
E The tyre pressure is too low
for the work to be carried out, it may cause an uneven
wear of the tyre tread and damage to the tyre, the tractor is very unstable when driving.
•
F The tyre pressure is too high
for the work to be carried out, it may cause an uneven
wear of the tyre tread with a high risk for tyre damage in case of impacts and driving is
uncomfortable.
IMPORTANT:
When filling the tyre with air, always take into account the type
of tyres installed or their dimensions, the type of work to be performed and
equipment to be installed!
IMPORTANT:
The pressure values specified in the operating instructions apply
to optimal working conditions. Some differences can nevertheless occur,
depending on the type of surface and the load on the tractor, which must be taken
into account before filling the tyres!
Fig. 188
Summary of Contents for AGT 106
