OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
213
Malfunction
Cause
Solution
The
steering
wheel does not
allow
for
precise
steering.
Presence of air in the steering
system.
Bleed the system. This operation can only be
performed by an authorized service centre. (*)
The seals on steering cylinders are
worn.
Replace the seals. This operation can only be
performed by an authorized service centre. (*)
The
steering
wheel is not
working.
The hydraulic oil pressure is too
low.
Replace the fuel pump. This operation can
only be performed by an authorized service
centre. (*)
Low oil level.
Check the hydraulic oil level and add if
necessary.
Refer
to
the
chapter
“Maintenance”.
The steering mechanism cylinder
is defective.
Replace the cylinder. This operation can only
be performed by an authorized service centre.
(*)
Hydraulic pump failure.
Replace the fuel pump. This operation can
only be performed by an authorized service
centre. (*)
8.12.6
HYDRAULIC LIFT MECHANISM MALFUNCTIONS
Malfunction
Cause
Solution
The
hydraulic
mechanism is not
lifted when the
control lever is
moved.
The
hydraulic
mechanism
is
overloaded.
the
weight
of
the
implement exceeds the maximum
lifting capacity of the hydraulic lift
mechanism.
Disconnect the implement or reduce the
weight. Before connecting the implement,
make
sure
that
its characteristics
are
compatible with the tractor's characteristics.
The hydraulic oil level is too low.
Check the hydraulic oil level and add if
necessary. Refer to the chapter “Maintenance”.
Low hydraulic oil pressure.
Replace the fuel pump. This operation can
only be performed by an authorized service
centre. (*)
Check and replace any defective valves on the
hydraulic system. This operation can only be
performed by an authorized service centre. (*)
The hydraulic pump is damaged.
Replace the fuel pump. This operation can
only be performed by an authorized service
centre. (*)
The priority valve is damaged.
Replace the valve. This operation can only be
performed by an authorized service centre. (*)
The
hydraulic
mechanism
cannot bear the
selected height of
the implement.
The valve on the control device is
worn or damaged.
Replace the safety valve on the control device.
This operation can only be performed by an
authorized service centre. (*)
The float mode
does not operate
properly.
Incorrect adjustment of hydraulic
accumulator.
Adjust correctly. Refer to the chapter “Floating
hydraulics with support “.
Hydraulic accumulator failure.
Replace the hydraulic accumulator. This
operation can only be performed by an
authorized service centre. (*)
Switch valve failure.
Replace the valve. This operation can only be
performed by an authorized service centre. (*)
(*) - These operations should only be performed by an authorized service technician!
Summary of Contents for AGT 106
