OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
161
Fig. 184
8
TRACTOR MAINTENANCE
As the operator, you must always follow the maintenance recommendations described below.
•
Regularly perform maintenance operations on the tractor. Proper maintenance ensures a
long-life span and performance.
•
Only use original replacement parts for replacing worn parts and only use oils and
lubricants recommended by the manufacturer. Do not use other brands of oils or blends
with characteristics that differ from the ones prescribed.
•
Regularly check the wheel screws, other important screws on the tractor and the joints of
hydraulic and electrical connection for proper tightening.
•
Unless otherwise specified, all maintenance operations must be performed with the
tractor turned off.
•
Maintenance work on the engine or near the engine must be performed when the engine
is completely cold.
•
During maintenance work in the engine compartment, make sure that the engine cover is
properly supported to prevent it from falling and causing crushing injuries of body parts.
•
After completing maintenance operations, clean the work area. Do not leave any parts or
harmful liquids in the environment, but remove them in accordance with local
regulations.
•
The personnel performing maintenance work must be familiar with the procedures,
comply with the safety instructions and take all necessary actions to ensure the workplace
safety.
8.1
TRACTOR LIFTING POINTS
The recommended points for lifting the tractor, see Fig. 184.
Position A
- the rear right part of the axle, for lifting the rear right sleeve;
Position B -
rear hook point, for lifting the rear part of the tractor;
Position C
- the rear left part of the axle, for lifting the rear left sleeve;
Position D
- the front right part of the axle, for lifting the front right sleeve;
Position E
- the front left part of the axle, for lifting the front left sleeve;
Position F
- front hook point, for lifting the front part of the tractor.
IMPORTANT:
Maintenance work on the tractor can only be performed by
authorized service centres complying with the manufacturer's instructions. Failure
to observe this recommendation and the maintenance intervals specified in the
operating instructions will void the warranty!
Tractor from below
Summary of Contents for AGT 106
