OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
128
Fig. 149
7.3
STARTING THE TRACTOR
When purchased, the tractor is immediately ready for use. However, we RECOMMEND that the
tractor is not operated at full load for
at least 20 hours of operation
to ensure that all the
moving parts are properly worn in. By following this advice, you will ensure efficient
performance and long service life of the tractor. During the first hours of operation, follow the
instructions below.
•
After the engine is started, leave it running in idle for a few minutes.
•
Do not expose the engine to excessive load during the initial use. If this cannot be
avoided, it should be done gradually.
•
Leave the engine running for a few moments before shutting off the tractor.
•
Regularly check the engine oil level during the first hours of operation. After the first 50
hours of operation, change the oil and the oil filter.
7.3.1
STARTING THE ENGINE
Before starting the tractor, always check that there is enough oil in the engine, enough liquid in
the radiator and enough fuel in the tank.
The tractor is equipped with safety devices to prevent immediate starting. The operator must
follow the proper starting procedure and fulfil all the conditions described below.
Summary of Contents for AGT 106
