Mitsubishi Electric 3F-14C-WINE, Руководство пользователя

Страница: 257 / 646

13-257 13-257
13.7.4. PROFIBUS parameters
This sets the PROFIBUS information in the robot controller.
Set parameters while connected to the robot controller.
Double-click [Field network parameter] -> [PROFIBUS] under the [Parameter] item to be edited from the project
tree.
After you change a parameter value, you can rewrite the parameters in the robot controller by clicking the [Write]
button.
Figure 13-71 PROFIBUS parameters
You can reset PROFIBUS interface card errors by pressing the [Err. Cancel] button. After that the same error will
not occur. It is valid while the power supply of the Robot Controller is ON. When the power supply is turned OFF,
the error may occur again.
You can reference explanations of the displayed parameters by pressing the [Explain] button.
This function can only be used with CR800-D/CR750-D/CRnD-700/CRn-500 series robot controller.
Caution