Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 74 / 774

■
Use to associate the map list with an NBMA interface when configuring static
mapping.
■
You can issue this command before or after the map-list command without
changing anything.
■
This command is available in Interface Configuration mode only.
■
See the map-list command.
■
Example
host1(config-if)# map-group charlie
■
Use the no version to remove the association.
■
See map-group.
map-list
■
Use to create a map list when configuring static mapped NBMA interfaces.
■
Limit the name of the map list to no more than 31 characters.
■
You can create multiple map lists; however, you can associate only one map list
with each physical interface.
■
If a map list contains an entry for a VCD that was previously configured to run
InARP, the map-group command fails. If this is the case, either reconfigure the
circuit with InARP disabled, or remove the entry for that circuit from the map
list.
■
Example
host1(config)# map-list charlie
■
Use the no version to remove the map list.
■
See map-list.
Assigning Descriptions to Interfaces
You can use the description commands to assign a text description or an alias to an
interface, so that other show commands can display that information.
atm aal5 description
■
Use to assign a text description or alias to an ATM AAL5 interface.
■
Use the show atm aal5 interface command to display the text description.
■
Example
host1(config-if)# atm aal5 description boston01
■
Use the no version to remove the text description or alias.
■
See atm aal5 description.
42 ■
Assigning Descriptions to Interfaces
JUNOSe 11.1.x Link Layer Configuration Guide