Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 349 / 774

Configuring Other PPP Attributes
The available ppp command options are the same for interfaces whether they are
configured with PPP or MLPPP.
encapsulation mlppp
■
Use to configure MLPPP as the encapsulation method on an individual interface.
■
Use this command only within the context of an individual interface. Issuing this
command creates an MLPPP link interface, also referred to as an MLPPP bundle
member.
■
Example
host1(config)# interface serial 2/0:1/1
host1(config-if)# encapsulation mlppp
■
Use the no version to disable MLPPP on an interface.
■
See encapsulation mlppp.
interface mlppp
■
Use to create an MLPPP network interface, also known as the MLPPP bundle.
■
Example
host1(config-if)# interface mlppp group2
■
Use the no version to delete the MLPPP bundle. You must first delete the IP
interface, followed by deleting the bundle members (link interfaces); then you
can delete the MLPPP bundle.
NOTE: RADIUS supports the inclusion of the MLPPP Bundle Name VSA [26-62] in
Access-Request, Acct-Start, Acct-Stop, and Interim-Acct messages. For more
information, see
JUNOSe Broadband Access Configuration Guide .
■
See interface mlppp.
member-interface
■
Use to add an MLPPP link interface—also known as an MLPPP bundle
member—to an MLPPP bundle.
■
Example
host1(config-if)# member-interface serial 2/0:1/1
■
Use the no version to remove the specified interface from the MLPPP bundle.
■
See member interface.
ppp hash-link-selection
Configuring Static MLPPP
■ 317
Chapter 9: Configuring Multilink PPP