Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 482 / 774

■
Use the no version, without the MAC address, to remove bridged Ethernet as
the encapsulation method on the interface.
■
See encapsulation bridge1483.
encapsulation ppp
■
Use to configure PPP as the encapsulation method for an interface.
■
Example
host1(config-subif)# encapsulation ppp
■
Use the no version to remove PPP as the encapsulation method on the interface.
■
See encapsulation ppp.
interface atm
■
Use to configure an ATM interface or subinterface type.
■
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310
router, use the
slot / port .[ subinterface ] format.
■
slot —Number of the chassis slot
■
port —Port number on the I/O module
■
subinterface —Number of the subinterface in the range 1–2147483647
■
To specify an ATM interface for E120 and E320 routers, use the
slot / adapter / port [. subinterface ] format.
■
slot —Number of the chassis slot
■
adapter —Identifier for the IOA within the E320 chassis, either 0 or 1, where:
■
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
■
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
■
port —Port number on the IOA
■
subinterface —Number of the subinterface in the range 1–2147483647
■
For more information, see “Creating a Basic Configuration” on page 22 in
“Configuring ATM” on page 3.
■
Examples
host1(config)# interface atm 9/1.1 point-to-point
host1(config)# interface atm 5/0/1.1 point-to-point
■
Use the no version to remove the interface or subinterface.
■
See interface atm.
ip address
450 ■
Configuring Bridged Ethernet
JUNOSe 11.1.x Link Layer Configuration Guide