Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 554 / 774

For ERX7xx models, ERX14xx models, and ERX310 router, use the
slot / port [. subinterface ] format. For example, the following command specifies
ATM 1483 subinterface 10 on slot 0, port 1 of an ERX7xx model, ERX14xx model,
or ERX310 router.
host1(config)# interface atm 0/1.10
For E120 and E320 routers, use the slot / adapter / port [. subinterface ] format, which
includes an identifier for the bay in which the I/O adapter (IOA) resides. In the
software, adapter 0 identifies the right IOA bay (E120 router) and the upper IOA bay
(E320 router); adapter 1 identifies the left IOA bay (E120 router) and the lower IOA
bay (E320 router). For example, the following command specifies ATM 1483
subinterface 20 on slot 5, adapter 0, port 0 of an E320 router.
host1(config)# interface atm 5/0/0.20
For more information about supported interface types and specifiers on E Series
routers, see Interface Types and Specifiers in
JUNOSe Command Reference Guide .
References
For more information about RADIUS, consult the following resources:
■
RFC 2865—Remote Authentication Dial In User Service (RADIUS) (June 2000)
■
RFC 2866—RADIUS Accounting (June 2000)
About Configuring Dynamic Interfaces over Static ATM
To create dynamic interfaces over ATM, you create the static layers of the interface
first, and then configure them to support a dynamic interface by means of
autodetection. Figure 44 on page 522 shows an example of the interface stack for a
dynamic IP over ATM 1483 interface.
Figure 44: Configuring an ATM 1483 Interface to Support Dynamic Interfaces
522 ■
References
JUNOSe 11.1.x Link Layer Configuration Guide