Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 148 / 774

■
Use to configure one of the local management interface types.
■
LMI provides configuration and status information relating to the virtual circuits
operating over Frame Relay.
■
LMI specifies polling mechanisms to receive incremental and full-status updates
from the network.
■
E Series routers conform to the following LMI specifications:
■
ansi —ANSI T1.617 Annex D
■
q933a —ITU-T Q.933 Annex A
■
cisco —Original Group of Four specification developed by DEC, Northern
Telecom, Stratacom, and Cisco
■
none —Suppresses LMI
■
The default is cisco .
■
Example
host1(config-if)# frame-relay lmi-type ansi
■
Use the no version to return to the default LMI type.
■
See frame-relay lmi-type.
interface pos
Use to configure a POS interface in slot/port format:
■
■
slot —Router chassis slot
■
port —Line module port
■
Example
host1(config)# interface pos 0/1
■
Use the no version to remove the POS interface.
■
See interface pos.
interface serial
■
Use to configure a serial interface in the appropriate format by selecting a
previously configured physical interface on which you want to configure Frame
Relay. For example, for a channelized T3 interface use
slot/port:channel/subchannel .
■
Use to configure a Frame Relay subinterface in the appropriate format by selecting
a previously configured physical interface. For example, for a T3-Frame interface
use
slot/port.subinterface ; for a channelized T1/channelized E1 interface use
slot/port.channel-group.subinterface .
116 ■
Configuring Frame Relay
JUNOSe 11.1.x Link Layer Configuration Guide