Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 579 / 774

pppoe profile
■
Use to assign a profile to a static PPPoE major interface. The profile configuration
is used to dynamically configure an upper bridged Ethernet, IP, PPP, or PPPoE
interface.
■
Specify a profile name with up to 80 alphanumeric characters.
■
The default encapsulation type, any , applies to any autoconfigured encapsulation
that does not have a specific profile assignment.
■
Examples
host1(config-subif)# pppoe profile pppoeProfile4
host1(config-if)# pppoe profile any anyProfile
■
Use the no version to remove the profile assignment from the interface.
■
See pppoe profile.
svlan ethertype
■
Use to assign an Ethertype value for the S-VLAN subinterface.
■
Choose one of the following Ethertype values:
■
8100 —Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
■
9100 —Specifies Ethertype value 0x9100, which is the default
■
9200 —Specifies Ethertype value 0x9200
■
Use an Ethertype value that matches the Ethertype value set on the customer
premises equipment (CPE) to which your router connects.
■
Example
host1(config-if)# svlan ethertype 8100
■
Use the no version to restore the default value, 9100.
■
See svlan ethertype.
svlan id
■
Use to assign S-VLAN IDs and VLAN IDs to VLAN subinterfaces.
■
Use S-VLAN ID and VLAN ID numbers that are in the range 0–4095 and that are
unique within the Ethernet interface.
■
Issue the svlan id command before any upper bindings are made, such as IP or
PPPoE.
■
Example
host1(config-if)# svlan id 4 255
■
There is no no version.
■
See svlan id.
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
■ 547
Chapter 17: Configuring Dynamic Interfaces