Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 179 / 774

■
Example 2
host1# show frame-relay lmi interface mlframe-relay TEST
LMI information for frame relay DTE interface mlframe-relayTEST
DTE parameter N391 is 6, N392 is 3, N393 is 4, T391 is 10
Configured LMI type is ANSI, status is up
Number of interface down transitions is 0
Time since last status change 00:06:20
Enquiries sent: 39
Full enquiries sent: 7
Enquiry responses received: 39
Full enquiry responses received: 7
Async updates received: 0
Unknown messages received: 0
Loss of sequencing detected: 0
No response timeouts: 0
Last sequence number sent: 39
Last sequence number received: 39
■
See show frame-relay lmi.
show frame-relay map
■
Use to display the current Frame Relay and MLFR map entries.
■
Field descriptions
■
subinterface—Name and subinterface number of the MLFR bundle in the
format
bundle-name.subinterface-number
■
State of the subinterface—One of the following states:
■
Up — Traffic can flow on the interface
■
Offline — Traffic cannot flow because hardware is unavailable
■
Down — Traffic cannot flow because of a problem in the interface at the
current protocol layer
■
LowerLayerDown — Traffic cannot flow because of a problem in an
interface at a lower protocol layer
■
AdministrativelyDown — Traffic cannot flow because of manual
administrative intervention
■
DLCI number—Decimal value, hexadecimal value, and value as it appears
on the wire of the DLCI
■
Example
host1# show frame-relay map
Frame relay sub-interface mlframe-relayTEST.1 (up): DLCI 16(0x10,0x4)
Frame relay sub-interface mlframe-relayTEST.2 (up): DLCI 17(0x11,0x14)
■
See show frame-relay map
show frame-relay multilinkInterface
Monitoring MLFR
■ 147
Chapter 3: Configuring Multilink Frame Relay