Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 512 / 774

interface atm
■
Use to select an ATM interface or subinterface type.
■
Example
host1(config)# interface atm 3/2.1
■
Use the no version to remove the interface or subinterface.
■
See interface atm.
interface fastEthernet
■
Use to select a Fast Ethernet interface.
■
Example
host1(config)# interface fastEthernet 1/0.2
■
Use the no version to remove the interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or a
subinterface if the one above it still exists.
■
See interface fastEthernet.
interface gigabitEthernet
interface tenGigabitEthernet
■
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
■
Examples
host1(config)# interface gigabitEthernet 1/0
host1(config)# interface gigabitEthernet 4/0/1
host1(config)# interface tenGigabitEthernet 4/0/1
■
Use the no version to remove the interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or
subinterface if the one above it still exists.
■
See interface gigabitEthernet.
■
See interface tenGigabitEthernet.
Configuring Subscriber Policies
To configure a nondefault client subscriber policy:
1.
From Global Configuration mode, create the subscriber policy and assign it an
alphanumeric name.
host1(config)# subscriber-policy client01
This command accesses Subscriber Policy Configuration mode.
480 ■
Configuration Tasks
JUNOSe 11.1.x Link Layer Configuration Guide