Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 417 / 774

■
ERX1410 router
■
ERX710 router
■
ERX705 router
■
ERX310 router
Module Requirements
For information about the modules that support PPPoE interfaces on ERX14xx
models, ERX7xx models, and the ERX310 router:
■
See ERX Module Guide, Table 1, Module Combinations for detailed module
specifications.
■
See ERX Module Guide, Appendix A, Module Protocol Support for information about
the modules that support PPPoE.
For information about the modules that support PPPoE interfaces on the E120 and
E320 routers:
■
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
■
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support PPPoE.
Interface Specifiers
The configuration task examples in this chapter use the slot / port [. subinterface ] format
to specify the physical interface on which you want to configure PPPoE. However,
the interface specifier format that you use depends on the router that you are using.
For ERX7xx models, ERX14xx models, and ERX310 router, use the
slot / port [. subinterface ] format. For example, the following command specifies
ATM 1483 subinterface 10 on slot 0, port 1 of an ERX7xx model, ERX14xx model,
or ERX310 router.
host1(config)# interface atm 0/1.10
For E120 and E320 routers, use the slot / adapter / port [. subinterface ] format, which
includes an identifier for the bay in which the I/O adapter (IOA) resides. In the
software, adapter 0 identifies the right IOA bay (E120 router) and the upper IOA bay
(E320 router); adapter 1 identifies the left IOA bay (E120 router) and the lower IOA
bay (E320 router). For example, the following command specifies ATM 1483
subinterface 20 on slot 5, adapter 0, port 0 of an E320 router.
host1(config)# interface atm 5/0/0.20
For more information about supported interface types and specifiers on E Series
routers, see Interface Types and Specifiers in
JUNOSe Command Reference Guide .
Platform Considerations
■ 385
Chapter 12: Configuring Point-to-Point Protocol over Ethernet