Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 60 / 774

■
Use the no version to enable a disabled subinterface.
■
See atm atm1483 shutdown.
atm atm1483 snmp trap link-status
■
Use to enable SNMP link status traps on an ATM 1483 layer subinterface.
■
Example
host1(config-subif)# atm atm1483 snmp trap link-status
■
Use the no version to disable the traps.
■
See atm atm1483 snmp trap link-status.
atm auto-configuration
■
Use to enable autoconfiguration of ILMI. Entering the atm auto-configuration
command overrides any previous configuration of the atm uni-version command.
■
Autoconfiguration is enabled by default.
■
Example
host1(config-if)# atm auto-configuration
■
Use the no version to disable autoconfiguration and set the ILMI parameters to
the UNI version configured using the atm uni-version command, which has a
default value of UNI 4.0.
■
See atm auto-configuration.
atm cac
■
Use to enable CAC on the interface. You can set a subscription limit, so you can
oversubscribe the port, and the UBR weight, so you can limit the number of UBR
connections.
■
You cannot configure CAC on an ATM interface on which you have created a
bulk-configured VC range for use by a dynamic ATM 1483 subinterface.
Conversely, you cannot create a bulk-configured VC range on an ATM interface
on which you have configured CAC. For information about creating
bulk-configured VC ranges, see “Bulk Configuration of VC Ranges” on page 631
in “Configuring Dynamic Interfaces Using Bulk Configuration” on page 623.
■
Example
host1(config-if)# atm cac 3000000 ubr 3000
■
Use the no version to disable CAC on the interface.
■
See atm cac.
atm clock internal
■
Use to cause the ATM interface to generate the transmit clock internally.
■
You must specify one of the following:
28 ■
Setting Optional Parameters
JUNOSe 11.1.x Link Layer Configuration Guide