Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 142 / 774

Interface Specifiers
The interface specifier format that you use depends on the type of physical interface
on which you want to configure Frame Relay.
For more information about supported interface types and specifiers on E Series
routers, see Interface Types and Specifiers in
JUNOSe Command Reference Guide .
References
For more information about Frame Relay, consult the following resources:
■
RFC 2115—Management Information Base for Frame Relay DTEs Using SMIv2
(September 1997)
■
RFC 2863—The Interfaces Group MIB (June 2000)
■
RFC 2427—Multiprotocol Interconnect over Frame Relay (September 1998)
■
Frame Relay Forum—User-to-Network Implementation Agreement (UNI), FRF
1.1 (January 1996)
■
Frame Relay Forum—Frame Relay Fragmentation Implementation Agreement,
FRF.12 (December 1997)
■
ANSI T1.617 Annex D
■
ITU-T Recommendation Q.922, Integrated Services Digital Network (ISDN) Data
Link Layer Specification for Frame Mode Bearer Services; Annex A (February
1992)
■
ITU-T Q.933 Annex A
Before You Configure Frame Relay
Before you attempt to configure a Frame Relay interface, configure the physical line
interface over which Frame Relay traffic flows.
This process is described in the following chapters:
■
Chapter Configuring Channelized T3 Interfaces in JUNOSe Physical Layer
Configuration Guide
■
Chapter Configuring T3 and E3 Interfaces in JUNOSe Physical Layer Configuration
Guide
The procedures described in this chapter assume that a physical interface has been
configured.
110 ■
References
JUNOSe 11.1.x Link Layer Configuration Guide