Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 743 / 774

option 82 field of DHCP messages or in the DSL Forum VSA 26-1 of PPPoE PADR
and PADI packets. Using this keyword causes the router to display the
agent-circuit-identifier string in the command output.
■
Field descriptions
■
Interface—Type and specifier of the VLAN subinterface
■
Status—Status of the VLAN subinterface: up, down, dormant,
lowerLayerDown, absent
■
MTU—Maximum allowable size (in bytes) of the MTU for the VLAN
subinterface
■
Svlan Id—S-VLAN ID value, if configured
■
Vlan Id—VLAN ID value for the VLAN subinterface
■
Ethertype—S-VLAN Ethertype value, if configured
■
Type—Type of VLAN subinterface
■
Static—VLAN or S-VLAN subinterface was configured statically
■
Dynamic—VLAN or S-VLAN subinterface was configured dynamically
■
Auto configure interface(s)—Types of dynamic upper interfaces configured
with the
auto-configure command: IP or PPPoE
■
Detected dynamic interface—Type of dynamic upper interface detected
during autoconfiguration: IP, PPPoE, or (if no packet has been received)
none
■
Interface types in lockout—Encapsulation types currently experiencing
lockout: IP, PPPoE, or none
■
Lockout state (seconds)—Settings of encapsulation type lockout for the
upper-layer encapsulation type indicated
■
Min—Minimum lockout time, in seconds
■
Max—Maximum lockout time, in seconds
■
Current—Current lockout time, in seconds; displays 0 (zero) if lockout
is not occurring
■
Elapsed—Time elapsed into the lockout time, in seconds; displays 0
(zero) if lockout is not occurring
■
Next—Lockout time for the router to use for the next lockout event, in
seconds
■
In—Analysis of inbound traffic on this interface
■
Bytes—Number of bytes received on the VLAN or S-VLAN subinterface
■
Packets—Sum of all unicast, broadcast, and multicast packets received
on the VLAN or S-VLAN subinterface
Monitoring Dynamic Interfaces and Profiles
■ 711
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration