Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 444 / 774

host1(config)# interface atm 3/0.1
host1(config)# interface atm 3/0/0.1
■
Use the no version to remove the interface or subinterface.
■
See interface atm.
pppoe service-name-table
■
Use from Profile Configuration mode to assign a PPPoE service name table to a
profile for use by the dynamic PPPoE interface column associated with the profile.
■
Specify the name of the PPPoE service name table configured with the
pppoe-service-name-table command from Global Configuration mode.
■
Example
host1(config-profile)# pppoe service-name-table myServiceTable1
■
Use the no version to remove the PPPoE service name table assignment.
■
See pppoe service-name-table.
profile
■
Use from Global Configuration mode to create a profile name of up to 80
characters.
■
Use from Subinterface Configuration mode to assign a profile to an interface.
Specify
pppoe as the encapsulation type to which the profile applies.
■
Examples
host1(config)# profile myProfile
host1(config-subif)# profile pppoe myProfile
■
Use the no version to remove a profile (from Global Configuration mode) or to
remove the profile assignment (from Subinterface Configuration mode).
■
See profile.
Configuring PADS Packet Content
By default, an E Series router acting as an AC sends both the AC-Name and AC-Cookie
tags as part of the PADS packet when it confirms a session with a PPPoE client. These
tags are defined in RFC 2516 as follows:
■
AC-Name—String that uniquely identifies the particular AC
■
AC-Cookie—Tag used by the AC to help protect against denial of service (DoS)
attacks
If necessary for compatibility with your network equipment, you can issue the pppoe
pads disable-ac-info command to prevent the router from sending the AC-Name
and AC-Cookie tags in the PADS packet.
pppoe pads disable-ac-info
412 ■
Configuring PADS Packet Content
JUNOSe 11.1.x Link Layer Configuration Guide