Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 543 / 774

host1:vr1(config-if)# hdlc down-when-looped
11.
Assign an IP address to the interface.
host1:vr1(config-if)# ip address 160.1.0.1 255.255.255.0
Monitoring Cisco HDLC
You can monitor Cisco HDLC interfaces using the show hdlc interface command.
You can set a statistics baseline for Cisco HDLC interfaces, subinterfaces, or circuits
using the
baseline hdlc interface serial command.
You can use the filtering feature of the show command to include or exclude lines
of output based on a text string you specify. For details, see show Commands in
JUNOSe System Basics Configuration Guide .
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(
slot / adapter / port ).
baseline hdlc interface
■
Use to set a statistics baseline for Cisco HDLC interfaces. The router implements
the baseline by reading and storing the statistics at the time the baseline is set
and then subtracting this baseline whenever baseline-relative statistics are
retrieved.
■
Example
host1# baseline hdlc interface serial 2/0:1/1
■
There is no no version.
■
See baseline hdlc interface.
show hdlc interface
■
Use to display statistics for the specified HDLC interfaces.
■
You can specify the following keywords:
■
statistics —Displays interface statistics
■
delta —Specifies that baselined statistics are to be shown
■
status —Displays the operational status of all configured interfaces
■
closed —Displays interfaces with administrative status Closed
■
config —Displays configuration information
■
down —Displays interfaces with operational status Down
Monitoring Cisco HDLC
■ 511
Chapter 16: Configuring Cisco HDLC