Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 610 / 774

■
Use the no version to restore the default lifetime, 1800 seconds.
■
See ipv6 nd ra-lifetime.
ipv6 nd reachable-time
■
Use to specify the amount of time, in milliseconds, that the E Series router can
reach a remote IPv6 node after some reachability confirmation event has
occurred.
■
Example—Sets the reachable-time to 30,000 milliseconds
host1(config-profile)# ipv6 nd reachable-time 30000
■
Use the no version to restore the default value 0 milliseconds for router
advertisements and 3,600,000 milliseconds (1 hour) for Neighbor Discovery
activity of the E Series router.
■
See ipv6 nd reachable-time.
ipv6 nd suppress-ra
■
Use to suppress IPv6 router advertisement transmissions on a LAN local area
network (Ethernet) interface.
■
Example
host1(config-profile)# ipv6 nd suppress-ra
■
Use the no version to reenable the sending of IPv6 router advertisement
transmissions on the LAN (Ethernet) interface
■
See ipv6 nd suppress-ra.
ipv6 policy
■
Use to assign a policy list to the ingress or egress of an interface to which the
profile is attached.
■
Example
host1(config-profile)# ipv6 policy secondary-input my-policy
■
Use the no version to remove the association between a policy list and a profile.
■
See ipv6 policy
ipv6 sa-validate
■
Use to enable source address validation on an IPv6 interface.
■
Source address validation verifies that a packet has been sent from a valid source
address.
■
Example
host1(config-profile)# ipv6 sa-validate
578 ■
Configuring a Dynamic Interface from a Profile
JUNOSe 11.1.x Link Layer Configuration Guide