Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 209 / 774

The VLAN major interface is added.
3.
Create a VLAN subinterface by adding a subinterface number to the interface
identification command.
host1(config-if)# interface fastEthernet 4/1.1
4.
Do one of the following:
■
Assign a VLAN ID for the subinterface.
host1(config-if)# vlan id 400
■
Assign a VLAN ID and the optional unique MAC address for the subinterface.
host1(config-if)# vlan id 400 mac-address 0090.1a01.1234
5.
Create an IP interface on the same VLAN as the PPPoE interface.
host1(config-if)# ip address 164.10.6.71 255.255.255.0
6.
Specify PPPoE as the encapsulation method on the interface.
host1(config-if)# pppoe
7.
Create a PPPoE subinterface.
host1(config-if)# pppoe sub interface fastEthernet 4/1.1.1
8.
Specify PPP as the encapsulation method on the interface.
host1(config-if)# encapsulation ppp
9.
Assign an IP address and mask.
host1(config-if)# ip address 192.6.129.5 255.255.255.0
10.
(Optional) Configure additional PPPoE subinterfaces by completing Steps 7
through 9 using unique numbering.
To configure additional IP interfaces over the VLAN major interface:
1.
Create a new VLAN subinterface by adding a unique subinterface number to the
interface identification command.
host1(config-if)# interface fastEthernet 4/1.2
2.
Assign a VLAN ID for the subinterface.
host1(config-if)# vlan id 401
3.
Assign an IP address and mask.
host1(config-if)# ip address 164.10.6.51 255.255.255.0
Creating a VLAN Subinterface
■ 177
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces