Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 92 / 774

■
The oam-pvc command enables generation of F5 OAM loopback cells and F5
OAM VC integrity.
■
The oam ais-rdi command configures the alarm down count for successive AIS
and RDI alarm cells to 5.
In dsl-subscriber-class:
■
The encapsulation command sets the encapsulation method to aal5autoconfig .
■
The ubr command configures the UBR service category without a PCR.
To configure an ATM VC class with systemwide default values, you can issue the
vc-class atm command followed immediately by the exit command. For example,
the following commands create a VC class named default-vc-class. Because no attribute
values are explicitly specified in default-vc-class, the router applies the default values
for the commands listed in Table 8 on page 59. For information about the default
value for each command, see the command descriptions in this section.
! Configure VC class with default values.
host1(config)#
vc-class atm default-subscriber-class
host1(config-vc-class)# exit
host1(config)#
To verify the VC class configuration, use the show atm vc-class command. For
information about how to use this command, see “show atm vc-class” on page 99.
cbr
■
Use to configure the CBR service category on an ATM data PVC.
■
For detailed information about how to use this command, see “cbr” on page 48.
■
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
■
Example
host1(config-vc-class)# cbr 15000
host1(config-vc-class)# exit
■
Use the no version to restore the default service category, UBR without a PCR.
■
See cbr.
encapsulation
■
Use to configure the encapsulation method on an ATM data PVC.
■
For detailed information about how to use this command, see “encapsulation”
on page 50.
■
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
■
Example
host1(config-vc-class)# encapsulation aal5mux ip
host1(config-vc-class)# exit
60 ■
Configuring ATM VC Classes
JUNOSe 11.1.x Link Layer Configuration Guide