Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 291 / 774

Action
To display Ethernet OAM link-fault management settings for all interfaces on which
OAM is enabled:
host1# show ethernet oam lfm summary
FastEthernet4/0 is Up, Administrative status is Up
Ethernet OAM (ver 1)
Mode: Active, Discovery State: Send any
Remote address: 0090.0a38.0208
Flags: Remote-Stable Remote-State-Valid Local-Stable
Loopback: Supported, Remote enabled
FastEthernet4/1 is Down, Administrative status is Up
Ethernet OAM (ver 1)
Mode: Active, Discovery State: Fault
Remote address: 0090.0b92.032a
Flags: Local Evaluating
Loopback: Supported, Local enabled
Meaning
Table 14 on page 259 lists the show ethernet oam lfm summary command output
fields.
Table 14: show ethernet oam lfm summary Output Fields
Field Description Field Name
Status of the hardware on this interface:
■
Up—Hardware is operational
■
Down—Hardware is not operational
Interface type/name
interfaceSpecifier
Operational state that you configured for this interface:
■
Up—Interface is enabled
■
Down—Interface is disabled
Administrative status
Revision of the OAM configuration. A new revision results from
each change to the configuration. Ethernet OAM (ver 1)
Discovery mode of the interface:
■
Active—The interface discovers and monitors the peer on
the link if the peer also supports IEEE 802.3ah OAM
functionality. An OAM entity in active mode initiates the
discovery process by sending an Information OAM PDU to
the multicast address of the slow protocol (0180.c200.0002)
at a configured rate. The default discovery mode of the OAM
client is active
■
Passive—An OAM entity does not initiate the discovery
process. You cannot perform link-fault management if you
configure both the local client and the remote peer for
passive mode operation
Mode
MAC Address of the remote peer Remote address
Monitoring OAM Link-Fault Management Sessions on All Configured Interfaces
■ 259
Chapter 7: Configuring IEEE 802.3ah OAM Link-Fault Management