Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 441 / 774

PPPoE over Ethernet Configurations
To enable a PPPoE service name table for use with a static interface in PPPoE over
Ethernet configurations:
1.
Configure a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet physical
interface.
host1(config)# interface fastEthernet 4/1
2.
Select PPPoE as the encapsulation method on the interface. This command
creates the PPPoE major interface.
host1(config-if)# pppoe
3.
Assign the PPPoE service name table to the PPPoE major interface.
host1(config-if)# pppoe service-name-table myServiceTable1
interface fastEthernet
■
Use to select a Fast Ethernet interface.
■
Example
host1(config)# interface fastEthernet 4/1
■
Use the no version to remove IP from an interface or subinterface. You must
issue the no version from the highest level down; you cannot remove an interface
or subinterface if the one above it still exists.
■
See interface fastEthernet.
interface gigabitEthernet
interface tenGigabitEthernet
■
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
■
For information about specifying the Gigabit Ethernet or 10-Gigabit Ethernet
interface or subinterface, see “interface gigabitEthernet” on page 399 and
“interface tenGigabitEthernet” on page 399 on “interface tenGigabitEthernet” on
page 673.
■
Examples
host1(config)# interface gigabitEthernet 1/0
host1(config)# interface gigabitEthernet 4/0/1 6.0.0FRS
host1(config)# interface tenGigabitEthernet 4/0/1
■
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
Configuring PPPoE Service Name Tables
■ 409
Chapter 12: Configuring Point-to-Point Protocol over Ethernet