Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 442 / 774

■
See interface gigabitEthernet.
■
See interface tenGigabitEthernet.
pppoe
■
Use to specify PPPoE as the encapsulation method for the interface.
■
This command creates a PPPoE major interface.
■
Example
host1(config-if)# pppoe
■
Use the no version to remove the PPPoE major interface.
■
See pppoe.
pppoe service-name-table
■
Use from Interface Configuration mode to assign a PPPoE service name table to
a PPPoE major interface for use by a static Fast Ethernet, Gigabit Ethernet, or
10-Gigabit Ethernet interface.
■
Specify the name of the PPPoE service name table configured with the
pppoe-service-name-table command from Global Configuration mode.
■
Example
host1(config-if)# pppoe service-name-table myServiceTable1
■
Use the no version to remove the PPPoE service name table assignment.
■
See pppoe service-name-table.
Enabling PPPoE Service Name Tables for Use with Dynamic Interfaces
To enable a PPPoE service name table for use with a dynamic interface, add the
service name table to a profile that is dynamically assigned to the interface.
For complete details, see “Configuring a Dynamic Interface from a Profile” on page 563
in “Configuring Dynamic Interfaces” on page 515.
To enable a PPPoE service name table for use with a dynamic interface:
1.
Create a profile by assigning it a name.
host1(config)# profile baseProfile
2.
Assign the PPPoE service name table to the profile as a PPPoE characteristic.
host1(config-profile)# pppoe service-name-table myServiceTable1
3.
Exit Profile Configuration mode.
host1(config-profile)# exit
410 ■
Configuring PPPoE Service Name Tables
JUNOSe 11.1.x Link Layer Configuration Guide