Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 423 / 774

■
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
■
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
■
port —Port number on the IOA
■
subinterface —Number of the subinterface in the range 1–2147483647
■
For more information, see “Creating a Basic Configuration” on page 22 in
“Configuring ATM” on page 3.
■
Examples
host1(config)# interface atm 0/1.19
host1(config)# interface atm 0/0/1.19
■
Use the no version to remove the interface or subinterface.
■
See interface atm.
ip address
■
Use to assign an IP address and subnet mask to a subinterface.
■
Example
host1(config-if)# ip address 192.1.1.1 255.255.255.0
■
Use the no version to remove an IP address or disable IP processing.
■
See ip address.
pppoe acName
■
Use to configure an access concentrator (AC) name on the PPPoE interface. When
the AC (the server) receives a PPPoE Active Discovery Initiation (PADI) packet
that it can serve, it replies by sending a PPPoE Active Discovery Offer (PADO)
packet. The PADO packet contains the AC name configured using this command.
■
If the AC name is not configured, the router name is used.
■
The AC name can be a maximum of 64 characters.
■
Example
host1(config-subif)# pppoe acName CYM9876
■
Use the no version to remove the AC name.
■
See pppoe acName.
pppoe duplicate-protection
■
Use to prevent a client from establishing more than one session using the same
MAC address.
■
This feature is disabled by default.
Configuring PPPoE over ATM
■ 391
Chapter 12: Configuring Point-to-Point Protocol over Ethernet