Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 606 / 774

■
Use the no version to delete J-Flow statistics from the profile.
■
See ip route-cache flow sampled.
ip route-map ip-subscriber
■
Use to configure an interface for route-map processing and specify the route
map that is applied to the IP interface subscriber.
■
Example
host1(config-profile)# ip route-map ip-subscriber chicagoRouteMap
■
Use the no version to delete the route map.
■
See ip route-map ip-subscriber.
ip sa-validate
■
Use to enable source address validation on an IP interface.
■
Source address validation verifies that a packet has been sent from a valid source
address.
■
Example
host1(config-profile)# ip sa-validate
■
Use the no version to disable source address validation.
■
See ip sa-validate.
ip tcp adjust-mss
■
Use to modify the maximum segment size (MSS) for TCP SYN packets traveling
through the interface.
■
Example
host1(config-profile)# ip tcp adjust-mss 200
■
Use the no version to remove the MSS modification.
■
See ip tcp adjust-mss.
ip unnumbered
■
Use to specify the unnumbered interface with which dynamic interfaces created
with the profile are associated.
■
You can configure a loopback using RADIUS instead of adding one to the profile
using the
ip unnumbered loopback command.
■
Example
host1(config-profile)# ip unnumbered loopback 5
■
Use the no version to remove the assignment from the profile.
■
See ip unnumbered
574 ■
Configuring a Dynamic Interface from a Profile
JUNOSe 11.1.x Link Layer Configuration Guide