Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 58 / 774

host1(config-if)# atm vp-tunnel 2 128
■
Enable scrambling of the ATM cell payload on a T3 or an E3 interface.
host1(config-if)# ds3-scramble
■
Set the time interval at which the router records bit and packet rates.
host1(config-if)# load-interval 90
■
Place the interface into loopback mode for router-to-router testing.
host1(config-if)# loopback diagnostic
■
Disable an interface.
host1(config-if)# shutdown
Optional Tasks on ATM 1483 Subinterfaces
You can perform the following optional tasks on ATM 1483 subinterfaces:
■
Set the MTU.
host1(config-subif)# atm atm1483 mtu 7800
■
Configure SNMP link status traps.
host1(config-subif)# atm atm1483 snmp trap link-status
■
Set the administrative state of an ATM 1483 subinterface to disabled.
host1(config-subif)# atm atm1483 shutdown
■
Configure an advisory receive speed.
host1(config-subif)# atm atm1483 advisory-rx-speed 2000
atm aal5 shutdown
■
Use to set an ATM AAL5 interface administrative state to disabled.
■
When you set the administrative state of the ATM AAL5 interface to disabled,
the router automatically disables all F5 OAM services configured on the associated
VC, and prevents the VC from receiving or transmitting F5 OAM cells.
■
Example
host1(config-if)# atm aal5 shutdown
■
Use the no version to enable a disabled interface.
■
See atm aal5 shutdown.
atm aal5 snmp trap link-status
26 ■
Setting Optional Parameters
JUNOSe 11.1.x Link Layer Configuration Guide