Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 288 / 774

Transmit-interval: 1000 ms
Loss-threshold: 5 packets
Event Action: disable
High Threshold Action: disable
Remote-loopback: supported
Frame-seconds Error Monitor
Window: 30 (100 millisecond units)
Low threshold: 20 errored frames
High threshold: none
Remote-loopback:
Frames sent: 104437
Bytes sent: 16167885
Frames received: 104437
Bytes received: 16167885
Meaning
Table 13 on page 256 lists the show ethernet oam lfm status command output fields.
Table 13: show ethernet oam lfm status Output Fields
Field Description Field Name
Name and type of the Ethernet interface, in the interface specifier
format, for which link-fault management packet details are
displayed Interface type/name
interfaceSpecifier
Discovery mode of the interface:
■
Active—The interface discovers and monitors the peer on
the link if the peer also supports IEEE 802.3ah OAM
functionality. An OAM entity in active mode initiates the
discovery process by sending an Information OAM PDU to
the multicast address of the slow protocol (0180.c200.0002)
at a configured rate. The default discovery mode of the OAM
client is active
■
Passive—An OAM entity does not initiate the discovery
process. You cannot perform link-fault management if you
configure both the local client and the remote peer for
passive mode operation
Mode
Number of milliseconds, after which Information OAM PDUs are
sent from the local OAM entity to the remote peer to maintain
the OAM association in an active state Transmit-interval
Number of Information OAM PDUs that can be missed from the
remote peer before a link fault event is triggered Loss-threshold
256 ■
Monitoring OAM Link-Fault Management Configuration for an Interface
JUNOSe 11.1.x Link Layer Configuration Guide