Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 490 / 774

■
Use the optional keyword untagged to specify that frames be sent untagged.
The keyword is valid only for VLAN ID 0. It allows tagged frames to be received,
but sends out untagged frames.
■
Example
host1(config-subif)# vlan id 400
■
There is no no version.
■
See vlan id.
Configuring S-VLANs over Bridged Ethernet
S-VLANs over bridged Ethernet support the same set of higher-level protocols as
VLANs over bridged Ethernet. You configure S-VLANs over bridged Ethernet in the
same way that you configure VLANs over bridged Ethernet, with the addition of
certain commands.
Like VLANs, configuring S-VLANs over bridged Ethernet interfaces consists of two
basic tasks:
1.
Configure the layers up to and including the S-VLAN subinterface.
2.
Configure the higher-level protocols above the S-VLAN subinterface.
Before you can remove an S-VLAN subinterface, you must remove the upper-layer
interface stack.
NOTE: S-VLAN oversubscription is not supported on bridged Ethernet interfaces.
For more information about specifying ATM interfaces and subinterfaces, see Interface
Types and Specifiers in
JUNOSe Command Reference Guide .
Configuring S-VLAN Subinterfaces over Bridged Ethernet
To configure an S-VLAN subinterface over bridged Ethernet:
1.
Create an ATM 1483 subinterface and associated PVC.
host1(config)# interface atm 3/1.1
host1(config-subif)# atm pvc 1 5 33 aal5snap 0 0 0
2.
Specify bridged Ethernet as the encapsulation method for the ATM 1483
subinterface.
host1(config-subif)# encapsulation bridge1483
3.
Create a VLAN major interface by specifying VLAN as the encapsulation method
for the bridged Ethernet interface.
host1(config-subif)# encapsulation vlan
458 ■
Configuring S-VLANs over Bridged Ethernet
JUNOSe 11.1.x Link Layer Configuration Guide