Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 618 / 774

host1(config-profile)# ppp max-negotiations 15
■
Example 4—Restores the maximum number of LCP, IPCP, and IPv6CP
renegotiation attempts to the default value, 30
host1(config-profile)# no ppp max-negotiations
■
Use the no version to restore the default value, 30 renegotiation attempts.
■
See ppp max-negotiations.
ppp mru
■
Use to control the negotiation of the maximum receive unit (MRU).
■
Specify the number of bytes, in the range 64–65535.
■
We recommend you coordinate this value with the network administrator on
the other end of the line.
■
If the value configured for the PPP MRU is greater than the value of the lower-layer
MRU minus the PPP header length, the router logs a warning message and uses
the lesser of the configured MRU value or the lower-layer MRU value minus the
PPP header length to negotiate the local MRU.
■
If the value configured for the PPP MRU conflicts with a similar value configured
for another protocol, such as the MTU value for PPPoE, the router uses the lesser
of the two values.
■
Example
host1(config-if)# ppp mru 576
■
Use the no version to restore the default value, which causes PPP to use the
lower-layer MRU minus the PPP header length as the MRU value. added per
mkelkar for fix to cqid 72648 (FranS)
■
See ppp mru.
ppp multilink enable
■
Use in a profile to enable the creation of dynamic MLPPP interfaces.
■
Example
host1 (config-profile)# ppp multilink enable
■
Use the no version to cause the LNS to reject any incoming requests to create
dynamic MLPPP interfaces.
■
See ppp multilink enable.
ppp multilink multiclass
■
Use in a profile to enable multiclass MLPPP and the creation of multilink classes
on a dynamic MLPPP interface.
■
Example
host1 (config-profile)# ppp multilink multiclass multilink-classes 6
586 ■
Configuring a Dynamic Interface from a Profile
JUNOSe 11.1.x Link Layer Configuration Guide