Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 155 / 774

■
slot —Router chassis slot
■
port —CT3, T3, or E3 module I/O port
■
channel —T1 (DS1) channel
■
subchannel —Set of DS0 timeslots; for information, see section Fractional T1
in JUNOSe Physical Layer Configuration Guide
■
subinterface —User-assigned nonnegative number that identifies a Frame
Relay subinterface
■
Example
host1(config-if)# interface serial 5/0:4/1.1
■
Use the no version to remove the subinterface or the serial interface.
■
See interface serial.
ip address
■
Use to assign an IP address and subnet mask to a subinterface.
■
Example
host1((config-subif)# ip address 42.42.42.41 255.255.255.0
■
Use the no version to remove an IP address or to disable IP processing.
■
See ip address.
map-class frame-relay
■
Use to create a map class.
■
Example
host1(config)# map-class frame-relay testmap
■
Use the no version to remove a map class.
■
See map-class frame-relay.
Monitoring Frame Relay
Use the show frame-relay commands described in this section to monitor Frame
Relay interfaces.
You can set a statistics baseline for Frame Relay interfaces, subinterfaces, or circuits
using the
baseline frame-relay command.
You can use the output-filtering feature of the show command to include or exclude
lines of output based on a text string you specify. See show Commands in JUNOSe
System Basics Configuration Guide for details.
Monitoring Frame Relay
■ 123
Chapter 2: Configuring Frame Relay