Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Руководство по настройке

Страница: 578 / 774

■
Use the no version to remove IP from an interface or a subinterface. You must
issue the no version from the highest level down; you cannot remove an interface
or a subinterface if the one above it still exists.
■
See interface fastEthernet.
interface gigabitEthernet
interface tenGigabitEthernet
■
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
■
To specify a Gigabit Ethernet interface for ERX7xx models, ERX14xx models,
and ERX310 router, use the
slot / port [. subinterface ] format.
■
To specify a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface for E120
and E320 routers, use the
slot / adapter / port [. subinterface ] format.
■
For more information, see chapter Configuring Ethernet Interfaces in JUNOSe
Physical Layer Configuration Guide .
■
Examples
host1(config)# interface gigabitEthernet 1/0
host1(config)# interface gigabitEthernet 4/0/1
host1(config)# interface tenGigabitEthernet 4/0/1
■
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
■
See interface gigabitEthernet.
■
See interface tenGigabitEthernet.
ip address
■
Use to assign an IP address and subnet mask to an interface or a subinterface.
■
Example
host1(config-if)# ip address 192.1.1.1 255.255.255.0
■
Use the no version to remove an IP address or disable IP processing.
■
See ip address.
pppoe auto-configure
■
Use to set up the router to dynamically create PPPoE subinterfaces on the PPPoE
major interfaces.
■
Example
host1(config-subif)# pppoe auto-configure
■
Use the no version to remove this configuration.
■
See pppoe auto-configure.
546 ■
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
JUNOSe 11.1.x Link Layer Configuration Guide