ITT PumpSmart PS220, Руководство по конфигурации и эксплуатации

Страница: 82 / 300

PS220 Configuration & Operation Guide
81 PS220
Multipump
9. Configure MAX PUMPS ON:
1. “ARROW RIGHT” To change
2. “ARROWS” to change value
3. “Save”
4. “NEXT”
10. Configure the Stage/De-Stage Values for Pumps 2, 3 etc.
1. “ARROW RIGHT” To change
2. “ARROWS” to change value
3. “Save”
4. “ARROW DOWN”
5. Repeat steps 1-3 for the remaining pumps in your system (6 Maximum).
6. “Next”
11. Exit the Wizard
NOTE:
Once you have completed the Multipump Configuration Wizard you MUST send a setpoint reference change
from the source selected in Basic Startup, from each drives setpoint source to each drive. This will ensure that
the reference changes on each drive’s keypad display. This will confirm that the PS220’s are communicating
with each other properly. It should take 3-4 seconds for this change to visibly register across all the individu-
al drive’s keypads, when using keypad as the reference, you should see the Double Arrows (Up/Down) flash
during this time and the value should change after this flash.